rfc9071v2.txt		rfc9071.txt
	skipping to change at line 727 ¶		skipping to change at line 727 ¶
	| With audio and video media, the CSRC list would often contain		| With audio and video media, the CSRC list would often contain
	| all participants who are not muted, whereas text participants		| all participants who are not muted, whereas text participants
	| that don't type are completely silent and thus are not		| that don't type are completely silent and thus are not
	| represented in RTP packet CSRC lists.		| represented in RTP packet CSRC lists.
	3.10. Empty T140blocks		3.10. Empty T140blocks
	If no unsent T140blocks were available for a source at the time of		If no unsent T140blocks were available for a source at the time of
	populating a packet but already-transmitted T140blocks are available		populating a packet but already-transmitted T140blocks are available
	that have not yet been sent the full intended number of redundant		that have not yet been sent the full intended number of redundant
	transmissions, then the primary T140block in the packet is composed		transmissions, then the primary area in the packet is composed of an
	of an empty T140block and populated (without taking up any length) in		empty T140block and included (without taking up any length) in the
	a packet for transmission. The corresponding SSRC SHALL be placed as		packet for transmission. The corresponding SSRC SHALL be placed as
	usual in its place in the CSRC list.		usual in its place in the CSRC list.
	The first packet in the session, the first after a source switch, and		The first packet in the session, the first after a source switch, and
	the first after a pause SHALL be populated with the available		the first after a pause SHALL be populated with the available
	T140blocks for the source selected to be sent as the primary, and		T140blocks for the source selected to be sent as the primary, and
	empty T140blocks for the agreed-upon number of redundancy		empty T140blocks for the agreed-upon number of redundancy
	generations.		generations.
	3.11. Creation of the Redundancy		3.11. Creation of the Redundancy
	skipping to change at line 1150 ¶		skipping to change at line 1150 ¶
	The default maximum rate of reception of "text/t140" real-time text,		The default maximum rate of reception of "text/t140" real-time text,
	as specified in [RFC4103], is 30 characters per second. The actual		as specified in [RFC4103], is 30 characters per second. The actual
	rate is calculated without regard to any redundant text transmission		rate is calculated without regard to any redundant text transmission
	and is, in the multiparty case, evaluated for all sources		and is, in the multiparty case, evaluated for all sources
	contributing to transmission to a receiver. The value MAY be		contributing to transmission to a receiver. The value MAY be
	modified in the "cps" parameter of the "fmtp" attribute for the		modified in the "cps" parameter of the "fmtp" attribute for the
	"text/t140" format of the "text" media section.		"text/t140" format of the "text" media section.
	A mixer combining real-time text from a number of sources may		A mixer combining real-time text from a number of sources may
	occasionally have a higher combined flow of text coming from the		occasionally have a higher combined flow of text coming from the
	sources. Endpoints SHOULD therefore specify a suitable higher value		sources. Endpoints SHOULD therefore include a suitable higher value
	for the "cps" parameter, corresponding to its real reception		for the "cps" parameter, corresponding to its real reception
	capability. The default "cps" value 30 can be assumed to be		capability. The default "cps" value 30 can be assumed to be
	sufficient for small meetings and well-managed larger conferences		sufficient for small meetings and well-managed larger conferences
	with users only making manual text entry. A "cps" value of 90 can be		with users only making manual text entry. A "cps" value of 90 can be
	assumed to be sufficient even for large unmanaged conferences and for		assumed to be sufficient even for large unmanaged conferences and for
	cases when speech-to-text technologies are used for text entry. This		cases when speech-to-text technologies are used for text entry. This
	is also a reachable performance for receivers in modern technologies,		is also a reachable performance for receivers in modern technologies,
	and 90 is therefore the RECOMMENDED "cps" value. See [RFC4103] for		and 90 is therefore the RECOMMENDED "cps" value. See [RFC4103] for
	the format and use of the "cps" parameter. The same rules apply for		the format and use of the "cps" parameter. The same rules apply for
	the multiparty case.		the multiparty case.
	skipping to change at line 1425 ¶		skipping to change at line 1425 ¶
	switch if appropriate. Increase the display count by 1.		switch if appropriate. Increase the display count by 1.
	CR LF (U+000D U+000A): A supported, but not preferred, way of		CR LF (U+000D U+000A): A supported, but not preferred, way of
	requesting a new line. Check and perform a source switch if		requesting a new line. Check and perform a source switch if
	appropriate. Increase the display count by 1.		appropriate. Increase the display count by 1.
	INT (ESC U+0061): Interrupt (used to initiate the mode negotiation		INT (ESC U+0061): Interrupt (used to initiate the mode negotiation
	procedure). The display count SHALL NOT be altered.		procedure). The display count SHALL NOT be altered.
	SGR (U+009B Ps U+006D): Select Graphic Rendition. Ps represents the		SGR (U+009B Ps U+006D): Select Graphic Rendition. Ps represents the
	rendition parameters specified in [ISO6429]. The display count		rendition parameters specified in [ISO6429]. (For freely
	SHALL NOT be altered. The SGR code SHOULD be stored for the		available equivalent information, please see [ECMA-48].) The
	current source.		display count SHALL NOT be altered. The SGR code SHOULD be stored
			for the current source.
	SOS (U+0098): Start of String. Used as a general protocol element		SOS (U+0098): Start of String. Used as a general protocol element
	introducer, followed by a maximum 256-byte string and the ST. The		introducer, followed by a maximum 256-byte string and the ST. The
	display count SHALL NOT be altered.		display count SHALL NOT be altered.
	ST (U+009C): String Terminator. End of SOS string. The display		ST (U+009C): String Terminator. End of SOS string. The display
	count SHALL NOT be altered.		count SHALL NOT be altered.
	ESC (U+001B): Escape. Used in control strings. The display count		ESC (U+001B): Escape. Used in control strings. The display count
	SHALL NOT be altered for the complete escape code.		SHALL NOT be altered for the complete escape code.
	skipping to change at line 1787 ¶		skipping to change at line 1788 ¶
	As already stated in Section 3.18, security in media SHOULD be		As already stated in Section 3.18, security in media SHOULD be
	applied by using DTLS-SRTP [RFC5764] at the media level.		applied by using DTLS-SRTP [RFC5764] at the media level.
	Further security considerations specific to this application are		Further security considerations specific to this application are
	specified in Section 3.18.		specified in Section 3.18.
	11. References		11. References
	11.1. Normative References		11.1. Normative References
			[ECMA-48] Ecma International, "ECMA-48: Control functions for coded
			character sets", 5th edition, June 1991,
			<https://www.ecma-international.org/publications-and-
			standards/standards/ecma-48/>.
	[ISO6429] ISO/IEC, "Information technology - Control functions for		[ISO6429] ISO/IEC, "Information technology - Control functions for
	coded character sets", ISO/IEC ISO/IEC 6429:1992, December		coded character sets", ISO/IEC ISO/IEC 6429:1992, December
	1992, <https://www.iso.org/obp/ui/#iso:std:iso-		1992, <https://www.iso.org/obp/ui/#iso:std:iso-
	iec:6429:ed-3:v1:en>.		iec:6429:ed-3:v1:en>.
	[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate		[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
	Requirement Levels", BCP 14, RFC 2119,		Requirement Levels", BCP 14, RFC 2119,
	DOI 10.17487/RFC2119, March 1997,		DOI 10.17487/RFC2119, March 1997,
	<https://www.rfc-editor.org/info/rfc2119>.		<https://www.rfc-editor.org/info/rfc2119>.
End of changes. 4 change blocks.
	7 lines changed or deleted		13 lines changed or added
This html diff was produced by rfcdiff 1.48. The latest version is available from http://tools.ietf.org/tools/rfcdiff/